Alrighty. So I got the load resistors a few days ago but I'm not sure how to hook them up. I read the instructions online at eautoworks.com but it doesn't really make sense. It appears that they hook it to the bulb? Here's a picture of the led bulbs I bought and the resistor... (the caliper paint was for wes in another thread). So anyone have any idea how to wire this? Thanks!



EDIT: Oh... actually... maybe I do understand it now. The picture was just confusing because it looked like it being attached to the bulb itself. So I guess you connect one end to ground and the other to the turn signal wire. Got it!

EDIT2: Just wired up the rear signals! Haven't tested them yet because I want to wire the fronts too... came back in for a quick break because it's 26 degrees outside right now and windy! Can they make the stock wires any shorter!

EDIT3: Ok so the rear signals are working perfectly! But the front, I'm not sure what wire to tap into. There is a red with yellow stripe, solid black, and a black with white stripe. I tapped my bumper signal bulb to the red with rellow stripe wire so I guess that the signal wire? Which is the ground? Solid black I'm assuming? If I just tap into those two wires... I'm wondering if it will light up when I turn on my headlights like it's supposed to. I would think it should... any ideas? Tap into the solid black and red and yellow stripe wire?